PRC ED-T 1I5/2O5-4-HR-GN - T distributor - 1079659

Notes

Order information:	Alternatively, this item can be wired. For your specific requirements, please contact your local PHOENIX CONTACT subsidiary.
Note on application	For assembly notes, please refer to the packing slip
Safety note
Safety note	• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
		• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
		WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
		• Assembled products may not be manipulated or improperly opened.
		• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
		• When using the product in direct connection with third-party manufacturers, the user is responsible.
		• For operating voltages > 50 V AC, conductive connector housings must be grounded
		• Ensure that the protective or functional ground has been properly connected.
		• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
		• Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product
		• Only use tools recommended by Phoenix Contact
		• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
		• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
		• Operate the connector only when it is fully plugged in.
		• Operate the connector only when it is fully plugged in and interlocked.
		• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
		• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
		• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties

Product type	Power distributor
Product family	PRC 35
Type	T distributor
Coding	AD
Insulation characteristics
Protection class	II
Degree of pollution	2

Dimensions

Width	180 mm
Height	159 mm
Length	70 mm

Electrical properties

Nominal voltage ATD	400 V (III/2.00)
Rated surge voltage (III/2)	8 kV
Rated current	32 A (observe derating)

Mechanical properties

Mechanical data
Insertion/withdrawal cycles	2000 (Test specification: IEC 60512-13-2)
Insertion force	50 N ±10 N (Test specification: IEC 60512-13-2)

Material specifications

Color (Housing)	black (RAL 9005)
Color of the housing part	black
Material Housing	Polycarbonate
Material Contact carrier	PPE (Contact carrier)
Material Contact	CuZn (Contact material, Pb < 0.1)
Flammability rating according to UL 94	V0
Seal material	TPE
Contact surface material	Sn
O-ring material	Silicon
Material of locking screw	Polycarbonate, fiber-reinforced

Cable/line

Single wire, cross section	4 mm²
Halogen-free	yes

Environmental and real-life conditions

Ambient conditions
Degree of protection	IP66/IP67/IP69
Category of shock impact	IK08 (-25°C)
Ambient temperature (operation)	-40 °C ... 70 °C (Depending on the current carrying capacity/derating curve)
Ambient temperature (storage/transport)	-40 °C ... 70 °C
Ambient temperature (assembly)	-5 °C ... 85 °C

Tuotenumero	1079659
Pakkausyksikkö	1 Kappaletta
Vähimmäistilausmäärä	1 Kappaletta
Tuoteavain	ABLCCA
Tuotekoodi	ABLCCA
GTIN	4055626801025
Paino kappaletta kohti (sis. pakkauksen)	555,334 g
Paino kappaletta kohti (ilman pakkausta)	555,334 g
Tullitariffinumero	85444290
Alkuperämaa	PL

EU RoHS
Täyttää RoHS-direktiivin vaatimukset	Kyllä (Ei poikkeussäännöksiä)
China RoHS
Environment friendly use period (EFUP)	EFUP-E Ei raja-arvot ylittäviä vaarallisia aineita
EU REACH SVHC
Huomautus REACH-kandidaattiaineesta (CAS-nro)	Triphenyl phosphate (CAS-nro: 115-86-6)
SCIP	87ae10d8-4ca0-43a6-8082-81caedf2f77f

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

PRC ED-T 1I5/2O5-4-HR-GN - T distributor

1079659

Tuotetiedot

ECLASS

ETIM

UNSPSC

Yhteensopivat tuotteet

Edut

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

PRC ED-T 1I5/2O5-4-HR-GN - T distributor 1079659

Tuotetiedot

ECLASS

ETIM

UNSPSC

Yhteensopivat tuotteet

PRC 5-FC-MS6 8-21 - Connector 1014530

PRC 5-FC-FS6 8-21 HR - Coupler connector 1017632

PRC COVER F - Protective cap 1409236

PRC COVER M - Protective cap 1409237

PRC 5-CA-F-H07-4-5,0 - Connecting cable 1150674

PRC 5-CA-F-H07-4-2,5 - Connecting cable 1150675

PRC 5-CA-F-H07-4-1,0 - Connecting cable 1150676

PRC 5-CA-M-H07-4-5,0 - Connecting cable 1150677

PRC 5-CA-M-H07-4-2,5 - Connecting cable 1150678

PRC 5-CA-M-H07-4-1,0 - Connecting cable 1150679

PRC 5-CA-MF-H07-4-20,0 - Connecting cable 1150680

PRC 5-CA-MF-H07-4-10,0 - Connecting cable 1150681

PRC 5-CA-MF-H07-4-5,0 - Connecting cable 1150682

Edut

PRC ED-T 1I5/2O5-4-HR-GN - T distributor

1079659