PV-FT-CCF-C-4-260-BU-SP - Device connector front mounting
1628091
Device connector front mounting, Range of articles: SUNCLIX, rated current: 35 A, Connection method: Crimp, Contact connection type: Socket, cable length: 260000
Tuotetiedot
Safety note
Safety note
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
Product type
Panel feed-through
Product family
SUNCLIX
Insulation characteristics
Degree of pollution
2
Conductor connection
Tightening torque
1.8 Nm ±0.1 Nm
Width
18.6 mm
Height
18.6 mm
Length
43.2 mm
Rated voltage (III/2)
1000 V
Rated surge voltage (III/2)
12 kV
Rated current (4.0 mm²)
35 A
Flammability rating according to UL 94
V0
Insulating material group
III
Contact surface
Silver Ag
Cable seal material
Elastosil LR 3065/50
Contact material
Cu
Contact surface material
Ag
Outer sheath, material
PE-X
Cable length
260 m
Cable type
S02
Structure of individual litz in acc. with VDE 0295 / smallest wire diameter
56x0.3
External cable diameter
4.60 mm ±0.15 mm
Outer sheath, material
PE-X
External sheath, color
blue
Halogen-free
yes
Ambient conditions
Ambient temperature (operation) (male connector/female connector)
