DOKD 1,5-TG - Initiator/actuator terminal block
3011054

Initiator/actuator terminal block, Current and voltage are determined by the plug used., nom. voltage: 250 V, nominal current: 24 A, connection method: Screw connection, Rated cross section: 2.5 mm2, cross section: 0.2 mm2 - 4 mm2, connection method: Screw connection, cross section: 0.2 mm2 - 4 mm2, mounting: NS 35/7,5, NS 35/15, color: gray

Tuotetiedot

Yhteensopivat tuotteet

Edut

Same shape as DIK ... three-level initiator terminal blocks
The forks of the insertion bridge can be easily loosened for bridging between non-adjacent terminal blocks
Terminal blocks with red and green LEDs are available for optical signaling of the initiator and actuator wiring
The upper level contains the feed-through connections for the signal cable which can be labeled
Because the spine of the insertion bridge can be snapped into place with the terminal block housing, all the terminal points can be wired freely and the bridge can be securely positioned
Alternate wiring of an actuator followed by an initiator is easy
Unlike the DIK terminal blocks, the lower level of these output terminal blocks makes direct contact with the DIN rail and as a PE connection are marked yellow-green
The middle level supplies the connected actuators with power
PHOENIX CONTACT OY
Niittytie 11, 01300 Vantaa
Kysy kysymys +358 (0)9 350 9020