Conținuturile pe care le vizualizezi sunt personalizate pentru România. Vizualizare conținuturi pentru Statele Unite ale Americii | Selectează altă țară

RIF-1-RSC-LDP-24DC/1IC - Relay module

2909885

Preassembled relay module with screw connection, consisting of: relay base, power contact relay, plug-in display/interference suppression module, retaining bracket. Contact switching type: 1 N/O contact, max. inrush current up to 130 A peak, 80 A (20 ms), 24 V DC input voltage

Detalii despre produs

Descriere produs

Setul este alcătuit din

Notes on operation	FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21)

Product type	Relay Module
Product family	RIFLINE complete
Application	high inrush currents
Operating mode	100% operating factor
Mechanical service life	3x 10⁷ cycles
Insulation characteristics: Standards/regulations
Insulation	Safe isolation, reinforced insulation
Overvoltage category	III
Pollution degree	2
Data management status
Date of last data management	20.03.2025

Maximum power dissipation for nominal condition	0.43 W
Test voltage (Winding/contact)	4 kV AC (50 Hz, 1 min., winding/contact)
Standards/regulations
Rated insulation voltage	250 V AC
Rated surge voltage	6 kV

Coil side
Nominal input voltage U_N	24 V DC
Input voltage range	19.2 V DC ... 33.6 V DC (20 °C)
Input voltage range in reference to U_N	see diagram
Drive and function	monostable
Drive (polarity)	polarized
Typical input current at U_N	18 mA
Typical response time	8 ms
Typical release time	10 ms
Coil voltage	24 V DC
Protective circuit	Freewheeling diode; Freewheeling diode
Operating voltage display	Yellow LED

Switching
Contact switching type	1 N/O contact
Type of switch contact	Single contact
Contact material	AgSnO
Maximum switching voltage	250 V AC/DC (The separating plate PLC-ATP should be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules. Potential bridging is then carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage	12 V (100 mA)
Limiting continuous current	6 A
	10 A (Value is permissible if connections 11 and 21, as well as connections 14 and 24 are bridged.)
Maximum inrush current	80 A (20 ms)
	130 A (peak, at capacitive load, 230 V AC, 24 μF)
Min. switching current	100 mA (12 V DC)
Interrupting rating (ohmic load) max.	264 W (at 24 V DC, observe contact derating)
	58 W (at 48 V DC)
	48 W (at 60 V DC)
	50 W (at 110 V DC)
	80 W (at 220 V DC)
	2750 VA (at 250 V AC, observe contact derating)
Switching capacity min.	1200 mW
Utilization category CB Scheme (IEC 60947-5-1)	AC15, 6 A/250 V (N/O contact)
	DC13, 2 A/24 V (N/O contact)

Connection method	Screw connection
Stripping length	8 mm
Conductor cross section rigid	0.5 mm² ... 4 mm²
Conductor cross-section rigid (2 conductors with same cross section)	0.5 mm² ... 2.5 mm²
Conductor cross section flexible	0.5 mm² ... 4 mm²
	0.5 mm² ... 4 mm² (Ferrule with plastic sleeve)
Conductor cross section flexible (2 conductors with same cross section)	0.5 mm² ... 2.5 mm²
	0.5 mm² ... 1.5 mm² (TWIN ferrule with plastic sleeve)
Conductor cross section AWG	20 ... 10 (solid)
	20 ... 12 (flexible)
Tightening torque	0.5 Nm ... 0.6 Nm

Item dimensions
Width	16 mm
Height	90 mm
Depth	75 mm

Color	gray (RAL 7042)

Ambient conditions
Degree of protection (Relay base)	IP20 (Relay base)
Degree of protection (Relay)	RT II (Relay)
Degree of protection (Installation location)	≥ IP54 (Installation location)
Ambient temperature (operation)	-40 °C ... 70 °C
Ambient temperature (storage/transport)	-40 °C ... 85 °C
Altitude	≤ 2000 m

Corrosive gas test
Identification	ISA-S71.04. G3 Harsh Group
	EN 60068-2-60

Standards/regulations
Standards/regulations	IEC 60947-5-1

Mounting type	DIN rail mounting
Assembly note	in rows with zero spacing
Mounting position	any

Date comerciale

Număr articol	2909885
Unitate de ambalare	10 Bucată
Cantitate minimă pentru comandă	1 Bucată
Cod produs	DK6519
GTIN	4055626405223
Greutate pe bucată (inclusiv ambalajul)	69,47 g
Greutate pe bucată (fără ambalaj)	69,47 g
Cod tarifar vamal	85364110
Țara de origine	CN

Clasificări

Aprobări

Environmental product compliance

Produse compatibile

Accesorii

EU RoHS
Îndeplineşte cerinţele conform directivei RoHS	Da
reglementări excepţionale, dacă sunt cunoscute	7(a), 7(c)-I
China RoHS
Environment friendly use period (EFUP)	EFUP-50 Un tabel de declarații China RoHS legat de articol poate fi găsit în zona de descărcare a articolului respectiv la „Declarația producătorului”. Nu se emite și nu este necesar niciun tabel de declarații China RoHS pentru toate articolele EFUP-E.
EU REACH SVHC
Trimitere la substanţa candidată REACH (nr. CAS)	Lead (nr. CAS: 7439-92-1)

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

RIF-1-RSC-LDP-24DC/1IC - Relay module

2909885

Detalii despre produs

ECLASS

ETIM

UNSPSC

EAC

Produse compatibile

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

RIF-1-RSC-LDP-24DC/1IC - Relay module 2909885

Detalii despre produs

RIF-1-BSC/2X21 - Relay base 2900930

REL-MR- 24DC/1IC - Single relay 2961341

RIF-LDP-12-24 DC - Plug-in module 2900939

RIF-RH-1 - Retaining bracket 2900953

ECLASS

ETIM

UNSPSC

Produse compatibile

FBS 2-6 - Plug-in bridge 3030336

FBS 2-6 BU - Plug-in bridge 3036932

FBS 2-6 GY - Plug-in bridge 3032237

FBS 2-8 - Plug-in bridge 3030284

FBS 2-8 BU - Plug-in bridge 3032567

FBS 2-8 GY 7042 - Plug-in bridge 3032541

STP 5-2 - Marker carriers 0800967

RIF-1-V8/PT/FLK14/OUT - System connection 2905195

NS 35/ 7,5 PERF 2000MM - DIN rail perforated 0801733

NS 35/ 7,5 UNPERF 2000MM - DIN rail, unperforated 0801681

NS 35/ 7,5 WH PERF 2000MM - DIN rail perforated 1204119

NS 35/ 7,5 WH UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1204122

NS 35/ 7,5 AL UNPERF 2000MM - DIN rail, unperforated 0801704

NS 35/ 7,5 ZN PERF 2000MM - DIN rail perforated 1206421

NS 35/ 7,5 ZN UNPERF 2000MM - DIN rail, unperforated 1206434

NS 35/ 7,5 CU UNPERF 2000MM-VPE 10 - DIN rail, unperforated 0801762

NS 35/ 7,5 CAP - End cap 1206560

NS 35/15 PERF 2000MM - DIN rail perforated 1201730

NS 35/15 UNPERF 2000MM - DIN rail, unperforated 1201714

NS 35/15 WH PERF 2000MM - DIN rail perforated 0806602

NS 35/15 WH UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1204135

NS 35/15 AL UNPERF 2000MM - DIN rail, unperforated 1201756

NS 35/15 ZN PERF 2000MM - DIN rail perforated 1206599

NS 35/15 ZN UNPERF 2000MM - DIN rail, unperforated 1206586

NS 35/15 CU UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1201895

NS 35/15 CAP - End cap 1206573

NS 35/15-2,3 UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1201798

MPS-MT - Test plug 0201744

MPS-IH WH - Insulating sleeve 0201663

MPS-IH RD - Insulating sleeve 0201676

MPS-IH BU - Insulating sleeve 0201689

MPS-IH YE - Insulating sleeve 0201692

MPS-IH GN - Insulating sleeve 0201702

MPS-IH GY - Insulating sleeve 0201728

MPS-IH BK - Insulating sleeve 0201731

ZB 5 :UNBEDRUCKT - Zack marker strip 1050004

ZB 5 CUS - Zack marker strip 0824962

ZB 5,LGS:FORTL.ZAHLEN - Zack marker strip 1050017

ZB 5,QR:FORTL.ZAHLEN - Zack marker strip 1050020

ZB 5,LGS:GLEICHE ZAHLEN - Zack marker strip 1050033

ZB 5,LGS:L1-N,PE - Zack marker strip 1050415

UC-TM 5 - Marker for terminal blocks 0818108

UC-TM 5 CUS - Marker for terminal blocks 0824581

UCT-TM 5 - Marker for terminal blocks 0828734

UCT-TM 5 CUS - Marker for terminal blocks 0829595

GBS 5-25X12 - Group marker label for terminal marking 0810588

GBS 5-25X5 - Group marker label for terminal marking 0829126

STP 5-2-ZB - Marker carriers 3037643

ZB 15:UNBEDRUCKT - Zack marker strip 0811972

ZB 15 CUS - Zack marker strip 0824945

ZB 15,LGS:L1-N,PE - Zack marker strip 0811998

UC-TM 16 - Marker for terminal blocks 0819217

UC-TMF 16 - Marker for terminal blocks 0819262

RIF-1-BSC/2X21 - Relay base 2900930

REL-MR- 24DC/1IC - Single relay 2961341

RIF-LDP-12-24 DC - Plug-in module 2900939

RIF-RH-1 - Retaining bracket 2900953

RIF-1-RSC-LDP-24DC/1IC - Relay module

2909885