MACX PL-EX-T-UIREL-UP - Temperature measuring transducer - 2904910

Product properties

Product type	Temperature transmitter
Insulation characteristics
Overvoltage category	II
Pollution degree	2

Electrical properties

Electrical isolation	4-way, between input/output/power supply/switching output
Step response (0–99%)	1000 ms (With SIL)
Step response (0–99%)		700 ms (Without SIL)
Maximum temperature coefficient	0.01 %/K
Maximum transmission error	0.1 % (e.g. for Pt 100, 300 K span, 4 ... 20 mA)
Electrical isolation Input/output/power supply
Test voltage	2.5 kV AC (50 Hz, 60 s)
Electrical isolation Input/output
Electrical isolation	375 V (Peak value in accordance with IEC/EN 60079-11)
Electrical isolation Input/power supply
Electrical isolation	375 V (Peak value in accordance with IEC/EN 60079-11)
Electrical isolation Input/switching output
Electrical isolation	375 V (Peak value in accordance with IEC/EN 60079-11)
Electrical isolation Output/supply
Rated insulation voltage	300 V_rms
Insulation	Safe isolation in accordance with IEC/EN 61010-1
Supply
Supply voltage range	24 V ... 230 V AC/DC (-20 % ... +10 %, 50 Hz ... 60 Hz)
Typical current consumption	< 100 mA (24 V DC)
Power consumption	< 2.4 W

Input data

Signal
Input signal	Temperature
	Resistor
	Voltage
Measurement
Sensor types (RTD) that can be used	Pt, Ni, Cu sensors: 2, 3, 4-wire
Sensor types that can be used (TC)	B, E, J, K, N, R, S, T, L, U, CA, DA, A1G, A2G, A3G, MG, LG
Temperature measuring range	-200 °C ... 850 °C
Linear resistance measuring range	0 Ω ... 50 kΩ
Potentiometer resistance range	0 Ω ... 50 kΩ
Linear mV signal range	-1000 mV ... 1000 mV

Output data

Switching: Relay
Output description	1 SIL/PL
Configurable/programmable	Yes
Contact switching type	2 changeover contacts
Contact material	AgSnO₂, hard gold-plated
Maximum switching voltage	250 V AC (250 V DC)
Maximum inrush current	2 A (250 V AC)
	2 A (28 V DC)
	0.2 A (120 V DC)
Signal
Configurable/programmable	Yes
Current output signal	4 mA ... 20 mA (in the case of SIL; further free configuration without SIL)
Max. current output signal	22 mA
Load/output load current output	≤ 600 Ω (20 mA)
Behavior in the event of a sensor error	according to NE 43 or freely configurable

Connection data

Connection method	Screw connection
Stripping length	7 mm
Screw thread	M3
Conductor cross-section rigid	0.2 mm² ... 2.5 mm²
Conductor cross-section flexible	0.2 mm² ... 2.5 mm²
Conductor cross-section AWG	24 ... 14
Tightening torque	0.5 Nm ... 0.6 Nm

Ex data

Safety data
Max. internal inductance L_i	negligible
Max. internal capacitance C_i	44 nF
Max. output voltage U_o	6 V
Max. output current I_o	7.4 mA
Max. output power P_o	11 mW
Safety-related maximum voltage U_m	253 V AC/DC
IIC: Max. external inductivity L_o / Max. external capacitance C_o	100 mH / 1.3 µF
	10 mH / 1.7 µF
	1 mH / 2.6 µF
	0 mH / 10 µF
IIB: Max. external inductivity L_o / Max. external capacitance C_o	100 mH / 6.8 µF
	10 mH / 9.2 µF
	1 mH / 15 µF

Signaling

Status display	LED supply voltage, PWR (green)
	Red LED, flashing (line, sensor error, ERR)
	Red LED (module error, ERR)
	Yellow LED (switching output)

Dimensions

Width	35 mm
Height	112.5 mm
Depth	114.5 mm

Material specifications

Color	yellow (RAL 1018)
Flammability rating according to UL 94 (Housing)	V0 (Housing)
Housing material	PA 6.6-FR

Environmental and real-life conditions

Ambient conditions
Degree of protection	IP20 (not assessed by UL)
Ambient temperature (operation)	-20 °C ... 65 °C
Ambient temperature (storage/transport)	-40 °C ... 85 °C
Altitude	≤ 2000 m
Permissible humidity (operation)	typ. 5 % ... 95 % (non-condensing)
Shock (operation)	15g (IEC 60068-2-27)
Vibration (operation)	5g (IEC 60068-2-6)

Approvals

CE
Certificate	CE-compliant
ATEX
Identification	 II (1) G [Ex ia Ga] IIC
		 II (1) D [Ex ia Da] IIIC
		 II 3 G Ex nA nC ic IIC T4 Gc X
Certificate	IBExU 10 ATEX 1044
IECEx
Identification	[Ex ia Ga] IIC
		[Ex ia Da] IIIC
		Ex nA nC ic IIC T4 Gc X
Certificate	IECEx IBE 10.0004 X
UL, USA/Canada
Identification	UL 508 Listed
Certificate	, C.D.-No 83104549
Shipbuilding approval
Identification	C, EMC2
Certificate	DNV GL 11 564-14HH
Safety Integrity Level (SIL, IEC 61508)
Identification	2
Performance Level (ISO 13849)
Identification	d

EMC data

Electromagnetic compatibility	Conformance with EMC directive
Noise immunity	EN 61000-6-2
Note	When being exposed to interference, there may be minimal deviations.
Electromagnetic HF field
Designation	Electromagnetic RF field
Standards/regulations	EN 61000-4-3
Typical deviation from the measuring range final value	2 %
Fast transients (burst)
Designation	Fast transients (burst)
Standards/regulations	EN 61000-4-4
Typical deviation from the measuring range final value	2 %
Conducted interference
Designation	Conducted interferences
Standards/regulations	EN 61000-4-6
Typical deviation from the measuring range final value	2 %

Standards and regulations

Electrical isolation	4-way, between input/output/power supply/switching output

Mounting

N.º de artigo	2904910
Pcs./Emb	1 Unidade
Quantidade mínima de pedido	1 Unidade
Observação	Produção ligada a pedido (sem devolução)
Chave comercial	CK3
Chave de produto	DK1215
GTIN	4046356899789
Peso por unidade (inclusive embalagem)	321,8 g
Peso por unidade (excluindo embalagem)	180 g
Número do imposto alfandegário	85437090
País de origem	DE

China RoHS
Environment friendly use period (EFUP)	EFUP-50 Uma lista de declaração de acordo com a RoHS da China relativa a artigos encontra-se na área de transferências do respetivo artigo, em "Declaração do fabricante". Para todos os artigos com EFUP-E não é emitida nem necessária uma tabela de declaração de acordo com a RoHS da China.
EU REACH SVHC
Nota sobre as substâncias candidatas ao REACH (n.º CAS)	Nenhuma substância numa proporção superior a 0,1 % em massa

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

MACX PL-EX-T-UIREL-UP - Temperature measuring transducer

2904910

Detalhes dos produtos

UNSPSC

Produtos compatíveis

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

MACX PL-EX-T-UIREL-UP - Temperature measuring transducer 2904910

Detalhes dos produtos

UNSPSC

Produtos compatíveis

IFS-USB-PROG-ADAPTER - Programming adapter 2811271

MACX MCR-EX-I20 - Plug 2905679

MACX MCR-EX-CJC - Plug 2925002

UC-EMLP (11X9) - Plastic label 0819291

UC-EMLP (11X9) CUS - Plastic label 0824547

UC-EMLP (11X9) YE - Plastic label 0822602

UC-EMLP (11X9) YE CUS - Plastic label 0824548

UC-EMLP (11X9) SR - Plastic label 0828094

UC-EMLP (11X9) SR CUS - Plastic label 0828098

US-EMLP (11X9) - Plastic label 0828789

US-EMLP (11X9) YE - Plastic label 0828871

US-EMLP (11X9) SR - Plastic label 0828872

LS-EMLP (11X9) WH - Device marker 0831678

LS-EMLP (11X9) YE - Device marker 0831732

LS-EMLP (11X9) SR - Device marker 0831705

MPS-MT - Test plug 0201744

MPS-IH BK - Insulating sleeve 0201731

MPS-IH GY - Insulating sleeve 0201728

MPS-IH GN - Insulating sleeve 0201702

MPS-IH YE - Insulating sleeve 0201692

MPS-IH BU - Insulating sleeve 0201689

MPS-IH RD - Insulating sleeve 0201676

MPS-IH WH - Insulating sleeve 0201663

MACX PL-EX-T-UIREL-UP - Temperature measuring transducer

2904910