EAC
Approval ID: RU*C-DE.*08.B.00010CSA
Approval ID: LR 13631| Nominal voltage UN | Nominal current IN | Cross section AWG | Cross section mm2 | |
|---|---|---|---|---|
| keine | ||||
| 120 V | 16 A | |||
16-channel output relay module with screw connection and 50-pos. system connection, coil side is protected and non-isolated (optional), for Yokogawa SDV 541 cards, module width: 425 mm
| Product type | Interface module | 
| Insulation characteristics: Air clearances and creepage distances, input/output | |
| Insulation | Safe isolation, reinforced insulation | 
| Overvoltage category | III | 
| Pollution degree | 2 | 
| Insulation characteristics: Air and creepage distances, output/output | |
| Insulation | Basic insulation | 
| Overvoltage category | III | 
| Pollution degree | 2 | 
| Air clearances and creepage distances, input/output | |
| Rated insulation voltage | 300 V | 
| Rated surge voltage | 6 kV (1.2/50 μs) | 
| Air and creepage distances, output/output | |
| Rated insulation voltage | 300 V | 
| Rated surge voltage | 4 kV (1.2/50 μs) | 
| Supported controller YOKOGAWA ProSafe-RS | |
| Suitable I/O card | SDV541 | 
| Nominal input voltage UN | 24 V DC | 
| Input voltage range in reference to UN | 0.9 ... 1.1 | 
| Input voltage range | 21.6 V DC ... 26.4 V DC | 
| Typical input current at UN | 40 mA | 
| Protective circuit | Freewheeling diode | 
| Status display/channel | Yellow LED | 
| Switching | |
| Contact switching type | 1 N/O contact per channel | 
| Contact material | AgNi (90/10) gold-plated | 
| Maximum switching voltage | 230 V AC | 
| 63 V DC | |
| Limiting continuous current | 4 A (pluggable fuse) | 
| Maximum inrush current | Supply 24 V DC/2 A, (P1+, P2+), pluggable fuse (IEC 60127-3/IV, 2AT) | 
| Supply | |
| Connection method | Screw connection | 
| Number of positions | 6 | 
| Conductor cross-section rigid | 0.34 mm² ... 2.5 mm² | 
| Conductor cross-section flexible | 0.2 mm² ... 2.5 mm² | 
| Conductor cross-section AWG | 24 ... 12 | 
| Field level | |
| Connection method | Screw connection with disconnect knife | 
| Number of connections | 2 | 
| Number of positions | 20 | 
| Conductor cross-section rigid | 0.2 mm² ... 4 mm² | 
| Conductor cross-section flexible | 0.2 mm² ... 2.5 mm² | 
| Conductor cross-section AWG | 24 ... 12 | 
| Controller level | |
| Connection method | Yokogawa, KS compatible | 
| Number of connections | 2 | 
| Number of positions | 50 | 
| Tightening torque | 0.5 Nm | 
| Status display present | no | 
| Width | 424.5 mm | 
| Height | 127.5 mm | 
| Depth | 67 mm | 
| Ambient conditions | |
| Degree of protection | IP00 | 
| Degree of protection (Installation location) | ≥ IP54 (Installation location) | 
| Ambient temperature (operation) | -20 °C ... 50 °C | 
| Altitude | ≤ 2000 m | 
| Air clearances and creepage distances, input/output | |
| Standards/regulations | EN 61010-2-201 | 
| Air and creepage distances, output/output | |
| Standards/regulations | EN 61010-2-201 | 
| Mounting type | DIN rail mounting | 
| Mounting position | any | 
| Notes on operation | Observe the maximum switching power of the relays used | 
| Notes on operation | Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch. | 
| Notes on operation | The outputs are not suitable for switching different line conductors. The sum of the switching voltages used for adjacent outputs must not exceed the rated insulation voltage value | 
| Notes on operation | The necessary requirements for insulation (basic insulation or reinforced insulation) from adjacent modules (in DIN-rail direction) must be realized by applying suitable measures (e. g., partition plates). | 
| Notes on operation | For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met. | 
| Item number | 2319430 | 
| Packing unit | 1 pc | 
| Minimum order quantity | 1 pc | 
| Note | Made to order (non-returnable) | 
| Sales key | CK2 | 
| Product key | DK2A9N | 
| GTIN | 4046356550031 | 
| Weight per piece (including packing) | 1 516 g | 
| Weight per piece (excluding packing) | 1 516 g | 
| Customs tariff number | 85389099 | 
| Country of origin | DE | 
| ECLASS-13.0 | 27141152 | 
| ECLASS-15.0 | 27141152 | 
| ETIM 9.0 | EC002780 | 
| UNSPSC 21.0 | 39121400 | 
| Nominal voltage UN | Nominal current IN | Cross section AWG | Cross section mm2 | |
|---|---|---|---|---|
| keine | ||||
| 120 V | 16 A | |||
| EU RoHS | |
| Fulfills EU RoHS substance requirements | Yes | 
| Exemption | 6(c), 7(a), 7(c)-I | 
| China RoHS | |
| Environment friendly use period (EFUP) | EFUP-50 An article-related China RoHS declaration table can be found in the download area for the respective article under "Manufacturer declaration". For all articles with EFUP-E, no China RoHS declaration table issued and required. | 
| EU REACH SVHC | |
| REACH candidate substance (CAS No.) | Lead (CAS: 7439-92-1) | 
| SCIP | 425b662e-32af-464a-bc5e-6deef06a6b3b |