1. Home
  2. Products
  3. Safety relay modules and sensors
  4. Configurable safety modules
  5. Extension module - PSR-SPP- 24DC/TS/SDOR4/4X1
The figure shows a version with a screw connection
PSR-TBUS DIN rail connectors are used for cross-wiring between the modules.

Extension module - PSR-SPP- 24DC/TS/SDOR4/4X1
2986106

PSR-TRISAFE-M relay output extension module with 4 safe relay output contacts (choice of 4 single-channel or 2 two-channel relay contacts), 4 signal outputs; up to SIL 3, Cat. 4/PL e, SIL 3, EN 50156, pluggable Push-in terminal block

Downloads

Product Details

Product type Safety device
Application PSR-TRISAFE-M extension module
Insulation characteristics
Overvoltage category III
Pollution degree 2
Times
Response time max. 50 ms
Recovery time < 10 s
Maximum power dissipation for nominal condition 3932 mW (up to  40°C ambient temperature, at m = 4, n = 4, Iload = 4 A, Isignal = 50 mA)
1532 mW (up to  55°C ambient temperature, at m = 4, n = 4, Iload = 1 A, Isignal = 50 mA)
Nominal operating mode 100% operating factor
Interfaces DIN rail TBUS for connection to the master module, supplied as standard
Rated control circuit supply voltage US 18 V DC ... 30 V DC (Incl. all tolerances, incl. residual ripple)
Rated control circuit supply voltage US 24 V DC (Electrical supply via PSR-TBUS)
Rated control supply current IS Electrical supply via PSR-TBUS
74 mA (At 24 V DC, relay outputs set)
54 mA (At 24 V DC, relay outputs not set)
Protective circuit Yes, within the scope of the operating voltage limits
Status display 1 x green LED, 1 x red LED
Rated insulation voltage 250 V AC
Rated surge voltage/insulation 4 kV / basic insulation between output contact current paths (13/14, 23/24, 33/34, 43/44); 6 kV / safe isolation, reinforced insulation between output contact current paths (13/14, 23/24, 33/34, 43/44) and the other circuits
Maximum switching voltage 250 V AC/DC
24 V DC
Minimum switching voltage 5 V AC/DC
Limiting continuous current 4 A (see derating curve)
Maximum inrush current 6 A
Inrush current, minimum 5 mA
Switching capacity (3600/h cycles) 3 A (230 V (AC 15))
5 A (24 V (DC13))
Output fuse 6 A gL/gG
Response time max. 50 ms
Relay
Output description Relay contacts, safety-related N/O contacts
Number of outputs 4 (Single-channel)
2 (Two-channel, connected in pairs)
Contact type 4 relay output contacts
Contact material AgSnO2 (From HW03)
AgCuNi +0.2 ... 0.4 μm Au (up to HW02)
Switching voltage min. 12 V AC/DC (as of HW 03)
min. 5 V AC/DC (Up to HW02)
max. 250 V AC/DC
Switching current min. 3 mA (as of HW 03)
min. 5 mA (Up to HW02)
Switching capacity min. 60 mW
Limiting continuous current 4 A (see to derating)
Mechanical service life 10x 106 cycles
Output fuse 6 A (gL / gG)
4 A (gL/gG for low-demand applications)
Status display 4 x green LEDs
Signal
Output description Digital
Number of outputs 4
Voltage 24 V DC (Supply via A1/A2)
Limiting continuous current 50 mA
Protective circuit Yes, within the scope of the operating voltage limits
Short-circuit protection Yes
Connection technology
pluggable yes
Conductor connection
Connection method Push-in connection
Conductor cross section solid 0.2 mm² ... 1.5 mm²
Conductor cross section flexible, with ferrule without plastic sleeve 0.25 mm² ... 1.5 mm² (only together with CRIMPFOX 6)
Conductor cross-section AWG 24 ... 16
Width 22.5 mm
Height 112 mm
Depth 114.5 mm
Housing material Polyamide PA non-reinforced
Housing color yellow
Safety data
Stop category 0
Safety data: EN ISO 13849
Category 1 (1-channel parameterization)
4 (2-channel parameterization)
Performance level (PL) c (1-channel parameterization)
e (2-channel parameterization)
Safety data: EN 50156
Safety Integrity Level (SIL) max. 3 (Reference IEC 61508)
Safety data: IEC 61508 - High demand
Safety Integrity Level (SIL) 1 (1-channel parameterization)
3 (2-channel parameterization)
Proof test interval 240 Months
Duration of use 240 Months
Safety data: IEC 61508 - Low demand
Safety Integrity Level (SIL) 1 (1-channel parameterization)
Proof test interval 60 Months
Duration of use 240 Months
Ambient conditions
Degree of protection IP20
Min. degree of protection of inst. location IP54
Ambient temperature (operation) -20 °C ... 55 °C
Ambient temperature (storage/transport) -20 °C ... 70 °C
Maximum altitude max. 2000 m (See Appendix "Using PSR-TRISAFE modules at altitudes greater than 2000 m above sea level")
Max. permissible humidity (storage/transport) 75 % (On average, 85 % occasionally)
Max. permissible relative humidity (operation) 75 % (On average, 85 % occasionally)
Shock (operation) 10g (Δt = 11 ms, three shocks in each space direction)
10g (Δt = 16 ms, continuous shock, 1000 shocks in each space direction)
Vibration (operation) 2g
Air pressure (operation) 70 kPa ... 108 kPa (up to 3000 m above sea level)
Air pressure (storage/transport) 66 kPa ... 108 kPa (up to 3500 m above sea level)
Air clearances and creepage distances between the power circuits
Standards/regulations DIN EN 50178
Mounting type DIN rail mounting
Mounting position On horizontal DIN rail
Item number 2986106
Packing unit 1 pc
Minimum order quantity 1 pc
Sales Key C18
Product Key DNA332
Catalog Page Page 262 (C-6-2019)
GTIN 4046356536547
Weight per Piece (including packing) 200 g
Weight per Piece (excluding packing) 140 g
Customs tariff number 85371098
Country of origin DE

ECLASS

ECLASS-9.0 27371819
ECLASS-10.0.1 27371819
ECLASS-11.0 27371819

ETIM

ETIM 8.0 EC001449

UNSPSC

UNSPSC 21.0 39122200

UL Listed

Approval ID: FILE E 140324

cUL Listed

Approval ID: FILE E 140324

Functional Safety

Approval ID: 01/205/5151.03/17

cULus Listed

REACh SVHC Lead 7439-92-1
China RoHS Environmentally Friendly Use Period = 50 years
For information on hazardous substances, refer to the manufacturer’s declaration available under “Downloads”

Compatible Products