IP67 switches speed up the commissioning of assembly and test systems In machine building, IP67 switches network individual workstations

Depending on the component, the cast components go through several steps in which they are assembled and repeatedly checked. It is particularly important to test for pressure leaks. The challenge here is that components which have not yet been finally assembled and which have several openings must be checked. To carry out a leak test on the part level, the parts must be optimally clamped in the station, ensuring the relevant geometry is adhered to. Test pressure is then applied to the parts by the leak test system to check whether the pressure is maintained.

To integrate various technology components such as screwdriver controls, camera sensors, force-distance measuring systems, and operator panels in the individual workstations, KMS Automation uses an industrial Ethernet network. At the same time, the standard provides the basis of communication for a modular manufacturing concept.

To be able to connect the technology components easily and directly to the network, IP67 switches are mounted directly on the workstations’ sliding carriages. The devices have five Ethernet ports in the splash-proof M12 D-coded version. Pre-assembled cables allow on-site connection of the Ethernet components in the workstation. The switches are supplied via an M12 Power Connector, which feeds 24 V DC from the base frame of the station. Thanks to its narrow design, the FL Switch 1605 M12 saves space when integrated and also provides easy access to the cable outlets. It is secured to the sliding carriage using two M6 screws. The spatial arrangement of the individual workstations can usually only be specified to a limited extent. Here, directly accessible interfaces between the stations using M12 connectors prove advantageous.
Although KMS Automation must implement the systems according to the specific requirements of its customers, for efficiency reasons the company tries to use standardized technology wherever possible. This is why the machine builder focuses on using components and concepts that can be used and combined in a quick and versatile way. Pre-assembled cables are used both for Ethernet networking and to connect the sensors and actuators in the workstations. On the workstation bench, the I/O level is connected to SACB sensor/actuator boxes via M12 connectors. The base frame of the respective workstations contains the necessary control cabinet, so there is no need for a separate cabinet.
Switches from the SFN series, which are installed next to the controller on the DIN rail, are used to connect the Ethernet network in the base frame.