PSR-SPP- 24DC/RSM4/4X1
-
Safety relay module
2981541
2-channel over-speed and zero-speed safety relay up to SIL 3 or Cat. 4, PL e in accordance with EN ISO 13849, 4 N/O contacts, suitable for connecting incremental encoders and initiators, width: 45 mm, plug-in Push-in terminal block
Free download available.
Downloads
Product details
Product type | Safety device |
Application | Over-speed safety relay |
Zero-speed safety relay | |
Control | 2-channel |
Mechanical service life | > 50x 106 cycles |
Relay type | Electromechanical relay with force-guided contacts in accordance with IEC/EN 61810-3 |
Insulation characteristics: Air clearances and creepage distances between the power circuits | |
Overvoltage category | II |
Degree of pollution | 2 |
Maximum power dissipation for nominal condition | 2.4 W |
Nominal operating mode | 100% operating factor |
Interfaces | Encoder |
Initiator connection | |
Air clearances and creepage distances between the power circuits | |
Rated insulation voltage | 250 V |
Rated surge voltage/insulation | 4 kV / Basic isolation, (safe isolation, reinforced insulation and 6 kV between input circuit and enabling current paths.) |
General | |
Nominal input voltage UN | 24 V DC |
Input voltage range in reference to UN | 0.85 ... 1.1 |
Typical input current at UN | 100 mA |
Voltage at input/start and feedback circuit | approx. 24 V DC |
Typical response time | 15 ms |
Typical release time | 12 ms |
Recovery time | 1 s |
Protective circuit | Surge protection; Suppressor diode |
Limit frequency | 2 kHz (IN1, IN2) |
400 kHz (RJ45) | |
Status display | LED (green) |
Contact switching type | 4 enabling current paths |
Contact material | AgNi10, + 5 µm Au |
Maximum switching voltage | 250 V AC/DC (when the gold layer is destroyed) |
60 V AC/DC (with gold layer existing) | |
Minimum switching voltage | 100 mV AC/DC |
Limiting continuous current | 5 A |
100 mA (alarm outputs) | |
Maximum inrush current | 6 A |
Inrush current, minimum | 1 mA |
Sq. Total current | 42.25 A2 (ITH2 = I12 + I22 + I32 + I42) |
Interrupting rating (ohmic load) max. | 67 W (24 V DC, τ = 0 ms) |
36 W (48 V DC, τ = 0 ms) | |
43 MW (110 V DC, τ = 0 ms) | |
68 MW (220 V DC, τ = 0 ms) | |
Switching capacity min. | 1 mW |
Switching capacity (3600/h cycles) | 2 A (24 V (DC13)) |
3 A (230 V (AC15)) | |
Output fuse | 6 A gL |
Clock/signal | |
Number of outputs | 4 |
Connection technology | |
pluggable | yes |
Conductor connection | |
Connection method | Push-in connection |
Conductor cross section rigid | 0.2 mm² ... 1.5 mm² |
Conductor cross section flexible | 0.2 mm² ... 1.5 mm² |
Conductor cross section, flexible, with ferrule, with plastic sleeve | 0.25 mm² ... 1.5 mm² (only together with CRIMPFOX 6) |
Conductor cross section flexible, with ferrule without plastic sleeve | 0.25 mm² ... 1.5 mm² (only together with CRIMPFOX 6) |
Conductor cross-section AWG | 24 ... 16 |
Stripping length | 8 mm |
Width | 45 mm |
Height | 112 mm |
Depth | 114.5 mm |
Color | yellow |
Housing material | PA |
Safety data | |
Stop category | 0 |
Safety data: EN ISO 13849 | |
Category | 4 |
Performance level (PL) | e |
Safety data: IEC 61508 - High demand | |
Safety Integrity Level (SIL) | 3 |
Safety data: IEC 61508 - Low demand | |
Safety Integrity Level (SIL) | 3 |
Safety data: EN IEC 62061 | |
Safety Integrity Level (SIL) | 3 |
Ambient conditions | |
Degree of protection | IP20 |
Min. degree of protection of inst. location | IP54 |
Ambient temperature (operation) | -20 °C ... 55 °C |
Ambient temperature (storage/transport) | -40 °C ... 70 °C |
Maximum altitude | max. 2000 m (Above sea level) |
Max. permissible humidity (storage/transport) | 75 % (on average, 85% infrequently, non-condensing) |
Max. permissible relative humidity (operation) | 75 % (on average, 85% infrequently, non-condensing) |
Air clearances and creepage distances between the power circuits | |
Standards/regulations | DIN EN 60664-1 |
Mounting type | DIN rail mounting |
Assembly note | in rows with zero spacing |
Mounting position | any |
Item number | 2981541 |
Packing unit | 1 pc |
Minimum order quantity | 1 pc |
Sales key | DNA |
Product key | DNA242 |
GTIN | 4017918996833 |
Weight per piece (including packing) | 363.6 g |
Weight per piece (excluding packing) | 363.069 g |
Customs tariff number | 90328900 |
Country of origin | DE |
ECLASS
ECLASS-13.0 | 27371811 |
ETIM
ETIM 9.0 | EC001448 |
UNSPSC
UNSPSC 21.0 | 39122300 |
EU RoHS | |
Fulfills EU RoHS substance requirements | Yes (No exemptions) |
China RoHS | |
Environment friendly use period (EFUP) |
EFUP-E
No hazardous substances above the limits
|
EU REACH SVHC | |
REACH candidate substance (CAS No.) | No substance above 0.1 wt% |
Compatible products
-
-
CABLE-25/8/250/RSM/E-SIMO611D - Adapter cable 2901746
-
CABLE-15/8/250/RSM/INDEL - Adapter cable 2902338
-
CABLE- 9/8/250/RSM/ELAU - Adapter cable 2902984
-
CABLE-15/8/100/RSM/BM - Adapter cable 2904108
-
CABLE-25/8/250/RSM/SIMO611D - Adapter cable 2981583
-
CABLE-25/8/250/RSM/ARADEX - Adapter cable 2981596
-
CABLE-15/8/250/RSM/SIMO611D - Adapter cable 2981606
-
CABLE-15/8/250/RSM/MHD/G - Adapter cable 2981619
-
CABLE-15/8/250/RSM/SIN800 - Adapter cable 2981622
-
CABLE-15/8/250/RSM/FM-NC - Adapter cable 2981635
-
CABLE-15/8/250/RSM/DKC - Adapter cable 2981648
-
CABLE-15/8/250/RSM/AMK - Adapter cable 2981651
-
CABLE-15/8/250/RSM/SEW-X15 - Adapter cable 2981664
-
CABLE-15/8/250/RSM/PD - Adapter cable 2981758
-
CABLE- 9/8/250/RSM/LENZE - Adapter cable 2981826
-
CABLE-15/8/250/RSM/KINETIX - Adapter cable 2986698
-
CABLE-15/8/250/RSM/IHDUNI-SP - Adapter cable 2986973
-
CABLE-15/8/250/RSM/INDRADYN-2 - Adapter cable 2986986
-
CABLE-20/8/250/RSM/FANUC - Adapter cable 2986999
Your advantages
Easy configuration via software (PSR-RSM4)
Up to SIL 3 in accordance with IEC 61508
Standard sensors can be connected
PHOENIX CONTACT s.r.o.
Námestie Mateja Korvína 1, 811 07 Bratislava. Zapísaná v Obchodnom registri Okresného súdu Bratislava III, vložka číslo 48994/B.