PSR-SPP- 24DC/FSP2/2X1/1X2 - Coupling relay - 2986588

Product properties

Product type	Coupling relay
Product family	PSRclassic
Application	Safe switch off
	High demand
	Low demand
Control	1-channel
Mechanical service life	10x 10⁶ cycles
Relay type	Electromechanical relay with force-guided contacts in accordance with IEC/EN 61810-3
Insulation characteristics
Overvoltage category	III
Degree of pollution	2
Times
Typ. starting time with U_s	50 ms (with U_s when controlled via A1)
Typical release time	50 ms (with U_s when controlled via A1)
Recovery time	1 s

Electrical properties

Maximum power dissipation for nominal condition	2.4 W
Nominal operating mode	100% operating factor
Rated insulation voltage	250 V AC
Rated surge voltage/insulation	Safe isolation, reinforced insulation 6 kV between the control circuits (A1/A2), (31/32), (13/14, 23/24)
Supply
Designation	A1/A2
Rated control circuit supply voltage U_S	24 V DC -15 % / +10 %
Rated control supply current I_S	typ. 55 mA (typ. with U_S)
Power consumption at U_S	typ. 1.32 W
Inrush current	max. 100 mA (typ. with U_S)
Filter time	max. 5 ms (in the event of voltage dips at U_s)
		max. 2 ms (Test pulse width; high test pulse at A1/A2)
		≥ 100 ms (Test pulse width; high test pulse at A1/A2)
		Test pulse rate = 80 x Test pulse width
		max. 5 ms (Test pulse width; low test pulse at A1/A2)
		≥ 50 ms (Test pulse rate; low test pulse at A1/A2)
		Test pulse rate = 15 x Test pulse width
Protective circuit	Surge protection; Suppressor diode, 33 V (A1 - A2)

Output data

Relay: Enabling current paths (13/14, 23/24)
Output description	2 x N/O, undelayed
Number of outputs	2
Contact switching type	2 enabling current paths
Contact material	AgCuNi, + 0.2 µm Au
Switching power	min. 75 mW
Inrush current	max. 5 A
Switching capacity	5 A (24 V (DC13))
Switching capacity		5 A (230 V (AC15))
Limiting continuous current	5 A
Sq. Total current	50 A² (observe derating)
Switching frequency	max. 0.5 Hz
Mechanical service life	10⁷ cycles
Output fuse	10 A gL/gG
Relay: 31/32
Output description	1 N/C signal contact
Number of outputs	1
Contact switching type	1 confirmation current path
Contact material	AgCuNi, + 0.2 µm Au
Switching power	min. 75 mW
Inrush current	max. 100 mA
Switching capacity	5 A (24 V (DC13))
Switching capacity		5 A (230 V (AC15))
Limiting continuous current	100 mA
Mechanical service life	10⁷ cycles
Output fuse	4 A gL/gG

Connection data

Connection technology
pluggable	yes
Conductor connection
Connection method	Push-in connection
Conductor cross-section rigid	0.2 mm² ... 1.5 mm²
Conductor cross-section flexible	0.2 mm² ... 1.5 mm²
Conductor cross-section, flexible, with ferrule, with plastic sleeve	0.25 mm² ... 1.5 mm² (only together with CRIMPFOX 6)
Conductor cross-section flexible, with ferrule without plastic sleeve	0.25 mm² ... 1.5 mm² (only together with CRIMPFOX 6)
Conductor cross-section AWG	24 ... 16
Stripping length	8 mm

Signaling

Operating voltage display	1 x yellow LED

Dimensions

Width	17.5 mm
Height	112 mm
Depth	114.5 mm

Material specifications

Color (Housing)	yellow (RAL 1018)
Housing material	PA

Characteristics

Safety data
Stop category	0
Safety data: EN ISO 13849
Category	1 (Diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90 %)
Performance level (PL)	c (Diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90 %)
Safety data: EN 50156
Safety Integrity Level (SIL)	2
Safety data: IEC 61508 - High demand
Safety Integrity Level (SIL)	2 (max. 10% of the entire SIL; diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90% )
Safety data: IEC 61508 - Low demand
Safety Integrity Level (SIL)	2 (max. 10% of the entire SIL; diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90% )
Safety data: EN IEC 62061
Safety Integrity Level (SIL)	1 (max. 10% of the entire SIL; diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90% )

Environmental and real-life conditions

Ambient conditions
Degree of protection	IP20
Min. degree of protection of inst. location	IP54
Ambient temperature (operation)	-20 °C ... 55 °C (observe derating)
Ambient temperature (storage/transport)	-40 °C ... 70 °C
Maximum altitude	≤ 2000 m (Above sea level)
Max. permissible humidity (storage/transport)	75 % (on average, 85% infrequently, non-condensing)
Max. permissible relative humidity (operation)	75 % (on average, 85% infrequently, non-condensing)
Shock	15g
Vibration (operation)	10 Hz ... 150 Hz, 2g

Approvals

CE
Identification	CE-compliant

Mounting

Mounting type	DIN rail mounting
Mounting position	any

Item number	2986588
Packing unit	1 pc
Minimum order quantity	1 pc
Sales key	D21
Product key	DNA161
GTIN	4046356553339
Weight per piece (including packing)	140.5 g
Weight per piece (excluding packing)	136.5 g
Customs tariff number	85364900
Country of origin	DE

ECLASS-13.0	27371819
ECLASS-15.0	27371819
ECLASS-15.0 ASSET	27250101

EU RoHS
Fulfills EU RoHS substance requirements	Yes
Exemption	7(a), 7(c)-I
China RoHS
Environment friendly use period (EFUP)	EFUP-50 An article-related China RoHS declaration table can be found in the download area for the respective article under "Manufacturer declaration". For all articles with EFUP-E, no China RoHS declaration table issued and required.
EU REACH SVHC
REACH candidate substance (CAS No.)	Lead (CAS: 7439-92-1)
SCIP	9470ca4b-46fa-4223-aa6b-57675a8728f3

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

PSR-SPP- 24DC/FSP2/2X1/1X2 - Coupling relay

2986588

Product details

ECLASS

ETIM

UNSPSC

DNV GL

cULus Listed

Functional Safety

Compatible products

Your advantages

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

PSR-SPP- 24DC/FSP2/2X1/1X2 - Coupling relay 2986588

Product details

ECLASS

ETIM

UNSPSC

Compatible products

CRIMPFOX 6 - Crimping pliers 1212034

Your advantages

PSR-SPP- 24DC/FSP2/2X1/1X2 - Coupling relay

2986588