The CANopen® fieldbus coupler enables the flexible INTERBUS Inline automation kit to be operated on CANopen® networks as well. The fieldbus coupler allows an INTERBUS Inline station to be inserted at any point in a CANopen® network. The fieldbus coupler is a slave in the CANopen® network and a master in the lower-level INTERBUS Inline local bus. The fieldbus coupler allows an INTERBUS Inline station to be inserted at any point in a CANopen® network. The fieldbus coupler is a slave in the CANopen® network and a master in the lower-level INTERBUS Inline local bus. The address of the CANopen® slave can easily be set from outside by means of DIP switches. The CANopen® network is connected via a TWIN COMBICON connector. The operating voltage for the fieldbus coupler and the electronics of the connected automation terminals can be supplied via a separate power connector. For CANopen® configuration, the latest EDS (Electronica Data Sheet) file is available in the Product Information Service (see below). The CANopen® fieldbus coupler supports the proven INTERBUS Inline diagnostics as well as the typical diagnostics for CANopen®. Locally, LEDs enable precise diagnostics. Note the following during configuration: The total logic current of all the terminals connected to a CANopen® network must not exceed the maximum permissible total current of 2 A. Depending on the station configuration, the number of terminals that can be connected may be less than 63
