Device connector, front mounting - PV-FT-CM-C-6-1000-RD
Panel feed-through, Range of articles: Sunclix, Device connector, front mounting, housing material: PPE, color: black, min. conductor cross section: 6 mm2, Connection method: Crimp, Type of contact: Pin, cable length: 1000
Detalii despre produs
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
45 N ±10 N
Degree of pollution
Rated voltage (III/2)
Rated surge voltage (III/2)
Rated current (6.0 mm²)
45 N ±10 N
250 N ±50 N
Color of the housing part
Flammability rating according to UL 94
Insulating material group
Cable seal material
Elastosil LR 3065/50
Contact surface material
Contact carrier material
Structure of individual litz in acc. with VDE 0295 / smallest wire diameter
External cable diameter
5.4 mm ±0.15 mm
Outer sheath, material
External sheath, color
Single wire, cross section
Cable pull-out force
> 80 N
Degree of protection (when plugged in)
IP66 / IP68 (2 m / 24 h)
Degree of protection (not plugged in)
Ambient temperature (operation)
-40 °C ... 85 °C
Ambient temperature (assembly)
-25 °C ... 50 °C
Unitate de ambalare
Cantitate minimă pentru comandă
Produs la comandă (nereturnabil)
Greutate pe bucată (inclusiv ambalajul)
Greutate pe bucată (fără ambalaj)
Cod tarifar vamal
Țara de origine
Environmentally friendly use period: unlimited = EFUP-e