D-SUB coupling - VS-09-KU-BU/BU - 1689637

D-SUB coupling, shell size 1, socket, gender changer, shielded, connection direction straight, IP67 degree of protection


Save money: Best price starts from {0} pieces!


Technical data





Dimensional drawing  

Dimensional drawing
D-SUB coupling

Back to top

Mechanical characteristics

Overvoltage category III
Degree of pollution 2
Cable outlet straight
Weight 23.29 g
Flammability rating according to UL 94 V0
Back to top

Ambient conditions

Ambient temperature (operation) -40 °C ... 80 °C
Back to top

Material data

Contact surface material Hard gold-plated over nickel
Contact material Copper alloy
Contact carrier material Polyester GF
Housing material PA
Width 38.1 mm
Height 25 mm
Length 54 mm
Back to top

Electrical characteristics

Number of positions 9
Rated current 5 A
Overvoltage category III
Degree of pollution 2
Rated voltage (III/3) 125 V
Insertion/withdrawal cycles ≥ 200
Back to top

Standards and Regulations

Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Operate the connector only when it is fully plugged in and interlocked.
• Operate the connector only when it is fully plugged in.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
Back to top

Environmental Product Compliance

China RoHS Environmentally Friendly Use Period = 50 years
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration”
Back to top



ECLASS 10.0.1 27440302
ECLASS 11.0 27440302
ECLASS 4.0 27260700
ECLASS 4.1 27260700
ECLASS 5.0 27260700
ECLASS 5.1 27261200
ECLASS 6.0 27261200
ECLASS 7.0 27440302
ECLASS 9.0 27440302
Back to top


ETIM 2.0 EC000437
ETIM 3.0 EC000437
ETIM 4.0 EC000437
ETIM 6.0 EC001132
ETIM 7.0 EC001132
Back to top


UNSPSC 6.01 31261501
UNSPSC 7.0901 31261501
UNSPSC 11 31261501
UNSPSC 12.01 31261501
UNSPSC 13.2 39121522
UNSPSC 18.0 39121522
UNSPSC 19.0 39121522
UNSPSC 20.0 39121522
UNSPSC 21.0 39121522
Back to top


586 Fulling Mill Road
Middletown, PA 17057
(800) 888-7388

  • Create PDF
  • Send by Email
  • Feedback