Wireless set - ILB BT ADIO MUX-OMNI - 2884208

Wireless-MUX set, two modules with 16 digital inputs and outputs and 2 analog inputs and outputs (0 ... 20 mA, 0 ... 10 V) each, incl. omnidirectional antennas with 1.5 m  cable



Technical data





Connection diagram  

Connection diagram

Block diagram  

Block diagram

Dimensional drawing  

Dimensional drawing

Schematic diagram  

Schematic diagram

Schematic diagram  

Schematic diagram
Connecting cables

Schematic diagram  

Schematic diagram
Installation example

Schematic diagram  

Schematic diagram

Back to top


Utilization restriction EMC: class A product, see manufacturer's declaration in the download area
Back to top


Dimensional drawing
Width 95 mm
Height 123.4 mm
Depth 57 mm
Note on dimensions with connectors
Back to top

Ambient conditions

Ambient temperature (operation) -25 °C ... 60 °C
Ambient temperature (storage/transport) -25 °C ... 85 °C
Permissible humidity (operation) 95 % (non-condensing)
Permissible humidity (storage/transport) 95 %
Air pressure (operation) 795 hPa ... 1080 hPa (up to 2000 m above sea level)
Air pressure (storage/transport) 66 kPa ... 108 kPa (up to 3500 m above sea level)
Degree of protection IP20
Back to top

Wireless interface

Antenna connection method RSMA (female)
No. of channels 40
Wireless standard Based on Bluetooth 4.0
Modulation type GFSK (Gaussian Frequency Shift Keying)
Frequency range 2.402 GHz ... 2.48 GHz (ISM bandwidth)
Transmission power 5 dBm
Receiver sensitivity -95 dBm
Back to top

Power supply for module electronics

Connection method Inline connector
Supply voltage 24 V DC
Supply voltage range 19.2 V DC ... 30.5 V DC (via power connector)
Current consumption 60 mA (Communications power at 24 V DC, 25 °C)
25 mA (Actuator supply, +load current Digital OUT (8 A))
Type of protection Polarity protection, surge protection
Back to top

Digital inputs

Input name Digital inputs
Connection method Spring-cage connection
Connection technology 1-conductor
Number of inputs 16
Nominal input voltage UIN 24 V DC
Input voltage range "0" signal < 5 V
Input voltage range "1" signal > 15 V
Input frequency ≤ 10 Hz
Typical input current per channel 2.3 mA
Back to top

Digital outputs

Output name Digital outputs
Connection method Spring-cage connection
Connection technology 1-conductor
Number of outputs 16
Protective circuit Short-circuit protection, overload protection, protected against reverse voltages
Nominal output voltage 24 V DC
Output current 8 A (Total)
Nominal load, inductive 12 VA (1.2 H, 50 Ω)
Nominal load, lamp 12 W
Nominal load, ohmic 12 W (48 Ω)
Output current when switched off ≤ 10 µA (When not loaded, a voltage can be measured even at an output that is not set.)
Behavior with overload Auto restart
Behavior with inductive overload Output can be destroyed
Reverse voltage resistance to short pulses Reverse voltage proof
Back to top

Analog inputs

Description of the input Single ended
Input name Analog inputs
Number of inputs 2
Type of protection Surge voltage
Measured value resolution 12 bits
Current input signal 0 mA ... 20 mA
Input resistance current input 50 Ω
Voltage input signal 0 V ... 10 V
Input resistance of voltage input 130 kΩ
Back to top

Analog outputs

Number of outputs 2
Output name Analog outputs
Type of protection Transient protection
DAC resolution 12 Bit
Current output signal 0 mA ... 20 mA
Load/output load current output ≤ 500 Ω
Voltage output signal 0 V ... 10 V
Load/output load voltage output ≥ 2 kΩ
Back to top


Housing material PA 6.6-FR
Mounting type DIN rail
Color green
Net weight 885 g
Note on weight specifications one module, incl. connector, without antenna
Degree of pollution 2
MTBF 465 Years (Telcordia standard, 25°C temperature, 21% operating cycle (5 days a week, 8 hours a day))
140 Years (Telcordia standard, 40°C temperature, 34.25% operating cycle (5 days a week, 12 hours a day))
MTTF 1458 Years (SN 29500 standard, temperature 25°C, operating cycle 21%)
557 Years (SN 29500 standard, temperature 40°C, operating cycle 34.25%)
219 Years (SN 29500 standard, temperature 40°C, operating cycle 100%)
Diagnostics messages Short-circuit or overload of the digital outputs LED
Wireless connection FS LED
Logic and actuator voltage LED
Link quality of the wireless connection 4 LEDs
Switch-on time ≤ 3 s (Until the wireless connection is established)
Delay time ≤ 10 ms (Latency, typical)
≤ 800 ms (Failsafe function for wireless interruption)
Wireless licenses Europe, additional countries in the e-shop
Back to top


Designation CE
Identification CE-compliant
Designation EAC
Identification EAC
Designation UL, USA/Canada
Identification 508 Listed
Designation Wireless approval, Europe
Additional text RED 2014/53/EU
Designation Wireless approval USA, FCC
Identification YG3ADIOMUX
Additional text FCC directive, part 15.247
Designation Wireless approval India, WPC
Certificate NR-ETA/5957
Designation Wireless approval Japan, MIC
Identification Japan MIC (RF) ID:202-LSF002
Designation Wireless approval Canada, IC
Certificate 4720B-ADIOMUX
Additional text ISC directive RSS 210
Designation Wireless approval Mexico, IFT
Certificate IFT RCPPHIL19-2130
Designation Wireless approval South Africa, ICASA
Certificate TA-2006/032
Designation Wireless approval South Korea, KC
Certificate MSIP-CRI-PCK-2884208
Back to top

Standards and Regulations

Electromagnetic compatibility Conformance with EMC Directive 2014/30/EU
Standards/specifications RED directive 2014/53/EU EN 300328 EN 61000-6-4 EN 61000-6-2 EN 62311 EN 60950
Mechanical tests Vibration resistance in acc. with EN 60068-2-6/IEC 60068-2-6 5g, 10...150 Hz, 2.5 h, in XYZ direction
Shock in acc. with EN 60068-2-27/IEC 60068-2-27 16g, 11 ms
Free from substances that could impair the application of coating according to P-VW 3.10.7 57 65 0 VW-AUDI-Seat central standard
Connection in acc. with standard CUL
Standards/regulations EN 61000-4-2
Contact discharge ± 6 kV (Test Level 3)
Indirect discharge ± 6 kV
Standards/regulations EN 61000-4-3
Frequency range 26 MHz ... 3 GHz (Test Level 3)
Standards/regulations EN 61000-4-4
Comments Criterion B
Standards/regulations EN 61000-4-5
Signal ± 1 kV (Signal line, asymmetrical)
Standards/regulations EN 61000-4-6
Frequency range 0.15 MHz ... 80 MHz
Protection class III
Overvoltage category II
Back to top

Environmental Product Compliance

REACh SVHC Lead 7439-92-1
China RoHS Environmentally Friendly Use Period = 50 years
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration”
Back to top

Articles in set

Wireless set ILB BT ADIO MUX 2702875

Wireless-MUX set, two modules with 16 digital inputs and outputs and 2 analog inputs and outputs (0 - 20 mA, 0 - 10 V) each, without antennas

Antenna RAD-ISM-2400-ANT-OMNI-2-1-RSMA 2701362

Omnidirectional antenna, 2.4 GHz, gain: 2 dBi, polarization: linear, opening angle: h/v 360°/75°, degree of protection: IP65, connection: RSMA (male), incl. 1.5 m / 5 ft. connecting cable and mounting bracket for wall mounting

Back to top



eCl@ss 10.0.1 27242602
eCl@ss 11.0 27242602
eCl@ss 4.0 27250300
eCl@ss 4.1 27250300
eCl@ss 5.0 27250600
eCl@ss 5.1 27242600
eCl@ss 6.0 27242600
eCl@ss 7.0 27242602
eCl@ss 9.0 27242602
Back to top


ETIM 2.0 EC001430
ETIM 3.0 EC001599
ETIM 4.0 EC001599
ETIM 5.0 EC001597
ETIM 6.0 EC001597
ETIM 7.0 EC001597
Back to top


UNSPSC 6.01 20142601
UNSPSC 7.0901 20142601
UNSPSC 11 20142601
UNSPSC 12.01 20142601
UNSPSC 13.2 20142601
UNSPSC 18.0 32151602
UNSPSC 19.0 32151602
UNSPSC 20.0 32151602
UNSPSC 21.0 32151602
Back to top

SEA Pte. Ltd.

105 Eunos Avenue 3
Singapore 409836
+65 6228 4900
  • Create PDF
  • Recommend
  • Feedback