Connector - PV-CF-S 2,5-6 (+) - 1774674

Photovoltaic connector, Range of articles: Sunclix, Connector, housing material: PPE, color: black, number of positions: 1, min. conductor cross section: 2.5 mm², max. conductor cross section: 6 mm², rated current: 27 A, Connection method: Spring-cage, Type of contact: Socket



Technical data




Dimensional drawing  

Dimensional drawing

Back to top


External cable diameter 5.5 mm ... 8 mm
Back to top

Ambient conditions

Degree of protection (when plugged in) IP66 / IP68 (2 m / 24 h)
Ambient temperature (operation) -40 °C ... 85 °C
Ambient temperature (assembly) -25 °C ... 50 °C
Back to top


Design Socket
Tightening torque nut 2 Nm ±0.1 Nm
Insertion force 45 N ±10 N
Disconnect force 250 N ±50 N (when locked)
Pull-out force of cable >= disconnect force > 330 N
Insertion/withdrawal cycles 100
Degree of pollution 2
Degree of protection IP66 / IP68 (2 m / 24 h)
Number of positions 1
Current 35 A
Rated surge voltage (III/3) 12.8 kV
pluggable Yes
Degree of protection IP66 / IP68 (2 m / 24 h)
Rated voltage 1100 V
Rated current (2.5 mm²) 27 A
Rated current (4.0 mm²) 35 A
Rated current (6.0 mm²) 40 A
Nominal cross section 6 mm²
Protection class II
Back to top


Color black
Insulating material mPPE
Contact material Cu
Contact surface material Ag
Cable gland material PPE
Back to top

Connection data

Connection method Spring-cage
Connection capacity 2.5 mm² ... 6 mm²
Contact resistance with connected conductor ≤ 0.45 mΩ
Stripping length 15 mm
Cable type H1Z2Z2-K lines
Type of contact Socket
Back to top

Standards and Regulations

Halogen-free yes
Flammability rating according to UL 94 V0
Safety note • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at under the product
• The installation notes/Design In documents online on the download page at must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
Back to top

Environmental Product Compliance

China RoHS Environmentally friendly use period: unlimited = EFUP-e
No hazardous substances above threshold values
Back to top



ECLASS 10.0.1 27440109
ECLASS 11.0 27440109
ECLASS 4.0 27260700
ECLASS 4.1 27260700
ECLASS 5.0 27260700
ECLASS 5.1 27260700
ECLASS 6.0 27260700
ECLASS 7.0 27440102
ECLASS 9.0 27440103
Back to top


ETIM 3.0 EC001121
ETIM 4.0 EC001121
ETIM 6.0 EC002061
Back to top


UNSPSC 6.01 30211810
UNSPSC 7.0901 39121409
UNSPSC 11 39121409
UNSPSC 12.01 39121409
UNSPSC 13.2 39121413
UNSPSC 18.0 39121413
UNSPSC 19.0 39121413
UNSPSC 20.0 39121413
UNSPSC 21.0 39121413
Back to top


Unit 15C, 906-930 Great South Road, Penrose
Auckland 1061
New Zealand

Phone: 0508 474 636
Toll Free (Local)
09 950 8495
  • Create PDF
  • Recommend
  • Feedback