VIOK 1,5-D/TG/D/PE - Installation protective conductor terminal block

3011067

Product details

General	Current and voltage are determined by the plug used.

Product type	Ground terminal block
Number of connections	7
Number of rows	4
Insulation characteristics
Overvoltage category	III
Degree of pollution	3

Rated surge voltage	4 kV
Maximum power dissipation for nominal condition	0.77 W

Number of connections per level	2
Nominal cross section	2.5 mm²
2nd, 3rd and 4th level
Connection method	Screw connection
Screw thread	M3
Note	Please observe the current carrying capacity of the DIN rails.
Tightening torque	0.5 ... 0.6 Nm
Stripping length	8 mm
Internal cylindrical gage	A3
Connection in acc. with standard	IEC 60947-7-1/IEC 60947-7-2
Conductor cross-section rigid	0.2 mm² ... 4 mm²
Cross section AWG	24 ... 12 (converted acc. to IEC)
Conductor cross-section flexible	0.2 mm² ... 2.5 mm²
Conductor cross-section, flexible [AWG]	24 ... 14 (converted acc. to IEC)
Conductor cross-section flexible (ferrule without plastic sleeve)	0.25 mm² ... 2.5 mm²
Flexible conductor cross-section (ferrule with plastic sleeve)	0.25 mm² ... 2.5 mm²
Cross-section with insertion bridge, rigid	4 mm²
Cross-section with insertion bridge, flexible	2.5 mm²
Nominal current	24 A
Maximum load current	24 A (with 4 mm² conductor cross-section)
Nominal voltage	250 V (the voltage is determined by the component used)
Nominal cross section	2.5 mm²
Disconnect level
Connection method	Screw connection
Screw thread	M3
Tightening torque	0.5 ... 0.6 Nm
Stripping length	8 mm
Connection in acc. with standard	IEC 60947-7-1
Conductor cross-section rigid	0.2 mm² ... 4 mm²
Cross section AWG	24 ... 12 (converted acc. to IEC)
Conductor cross-section flexible	0.2 mm² ... 2.5 mm²
Conductor cross-section flexible (ferrule without plastic sleeve)	0.25 mm² ... 2.5 mm²
Flexible conductor cross-section (ferrule with plastic sleeve)	0.25 mm² ... 2.5 mm²
Cross-section with insertion bridge, rigid	4 mm²
Cross-section with insertion bridge, flexible	2.5 mm²
Nominal current	16 A
Maximum load current	16 A (with 4 mm² conductor cross-section)
Nominal voltage	250 V
Nominal cross section	1.5 mm²

Width	6.2 mm
Height	91.5 mm
Depth on NS 35/7,5	70 mm
Depth on NS 35/15	77.5 mm

Color	gray (RAL 7042)
Flammability rating according to UL 94	V2
Insulating material group	I
Insulating material	PA
Static insulating material application in cold	-60 °C
Temperature index of insulation material (DIN EN 60216-1 (VDE 0304-21))	130 °C
Relative insulation material temperature index (Elec., UL 746 B)	130 °C
Fire protection for rail vehicles (DIN EN 45545-2) R22	HL 1 - HL 3
Fire protection for rail vehicles (DIN EN 45545-2) R23	HL 1 - HL 3
Fire protection for rail vehicles (DIN EN 45545-2) R24	HL 1 - HL 3
Fire protection for rail vehicles (DIN EN 45545-2) R26	HL 1 - HL 3
Calorimetric heat release NFPA 130 (ASTM E 1354)	28 MJ/kg
Surface flammability NFPA 130 (ASTM E 162)	passed
Specific optical density of smoke NFPA 130 (ASTM E 662)	passed
Smoke gas toxicity NFPA 130 (SMP 800C)	passed

Mechanical data
Open side panel	No

Ambient conditions
Ambient temperature (operation)	-60 °C ... 110 °C (Operating temperature range incl. self-heating; for max. short-term operating temperature, see RTI Elec.)
Ambient temperature (storage/transport)	-25 °C ... 60 °C (for a short time, not exceeding 24 h, -60 °C to +70 °C)
Ambient temperature (assembly)	-5 °C ... 70 °C
Ambient temperature (actuation)	-5 °C ... 70 °C
Permissible humidity (operation)	20 % ... 90 %
Permissible humidity (storage/transport)	30 % ... 70 %

Connection in acc. with standard	IEC 60947-7-1/IEC 60947-7-2
	IEC 60947-7-1

Mounting type	NS 35/7,5
	NS 35/15

Commercial data

Item number	3011067
Packing unit	50 pc
Minimum order quantity	1 pc
Sales key	31BB12
Product key	BE1218
GTIN	4017918106676
Weight per piece (including packing)	30.45 g
Weight per piece (excluding packing)	30.45 g
Customs tariff number	85369010
Country of origin	PL

Classifications

Approvals

Approval Specification Data
	Nominal voltage U_N	Nominal current I_N	Cross section AWG	Cross section mm²
keine
	300 V	15 A	28 - 14

Approval Specification Data
	Nominal voltage U_N	Nominal current I_N	Cross section AWG
B
	300 V	15 A	30 - 14
PE connection			30 - 14
C
	150 V	15 A	30 - 14
PE connection			30 - 14
D
	150 V	15 A	30 - 14
PE connection			30 - 14

Environmental product compliance

Compatible products

Accessories

Your advantages

The upper level contains the feed-through connections for the signal cable which can be labeled

This terminal block is a combination of a DIK ... and DOK ... terminal block where a single terminal block can be used for initiators and actuators

The PE connection is located in the lower level

The two middle terminal points supply potential to the initiator

ECLASS-13.0	27250104
ECLASS-15.0	27250104

EU RoHS
Fulfills EU RoHS substance requirements	Yes (No exemptions)
China RoHS
Environment friendly use period (EFUP)	EFUP-E No hazardous substances above the limits
EU REACH SVHC
REACH candidate substance (CAS No.)	No substance above 0.1 wt%

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

VIOK 1,5-D/TG/D/PE - Installation protective conductor terminal block

3011067

Product details

ECLASS

ETIM

UNSPSC

CSA

EAC

cULus Recognized

Compatible products

Your advantages

Automate

Connect

Mark, assemble, and install

Supply, charge, and protect

Switch, Measure and Monitor

VIOK 1,5-D/TG/D/PE - Installation protective conductor terminal block 3011067

Product details

ECLASS

ETIM

UNSPSC

Compatible products

EB 80- DIK BU - Insertion bridge 2715940

EB 10- DIK GY - Insertion bridge 2715937

EB 10- DIK RD - Insertion bridge 2716774

EB 10- DIK BU - Insertion bridge 2716680

EB 80- DIK RD - Insertion bridge 2715953

ST-SILA250-UK 4 - Fuse plug 0921053

ST-SILED 60-UK 4 - Fuse plug 0921040

ST-SILED 24-UK 4 - Fuse plug 0921037

ST-SILED 12-UK 4 - Fuse plug 0921024

ST-SI-UK 4 - Fuse plug 0921011

SBS 6:UNBEDRUCKT - Marker card 1007222

ST-BE - Component connector 2802316

ST-BE-LA 24 - Component connector 2802374

ST-BE-LA230 - Component connector 2802387

ST-1N4007 - Component connector 2802329

ST-BE-VP - Component connector 2802332

ST-B250C1500 - Component connector 2802345

ST-K 4 - Isolating plug 5025462

NS 35/ 7,5 PERF 2000MM - DIN rail perforated 0801733

NS 35/ 7,5 UNPERF 2000MM - DIN rail, unperforated 0801681

NS 35/ 7,5 WH PERF 2000MM - DIN rail perforated 1204119

NS 35/ 7,5 WH UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1204122

NS 35/ 7,5 AL UNPERF 2000MM - DIN rail, unperforated 0801704

NS 35/ 7,5 ZN PERF 2000MM - DIN rail perforated 1206421

NS 35/ 7,5 ZN UNPERF 2000MM - DIN rail, unperforated 1206434

NS 35/ 7,5 CU UNPERF 2000MM-VPE 10 - DIN rail, unperforated 0801762

NS 35/ 7,5 CAP - End cap 1206560

NS 35/15 PERF 2000MM - DIN rail perforated 1201730

NS 35/15 UNPERF 2000MM - DIN rail, unperforated 1201714

NS 35/15 WH PERF 2000MM - DIN rail perforated 0806602

NS 35/15 WH UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1204135

NS 35/15 AL UNPERF 2000MM - DIN rail, unperforated 1201756

NS 35/15 ZN PERF 2000MM - DIN rail perforated 1206599

NS 35/15 ZN UNPERF 2000MM - DIN rail, unperforated 1206586

NS 35/15 CU UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1201895

NS 35/15 CAP - End cap 1206573

NS 35/15-2,3 UNPERF 2000MM-VPE 10 - DIN rail, unperforated 1201798

ZB 6:UNBEDRUCKT - Zack marker strip 1051003

ZB 6 CUS - Zack marker strip 0824992

ZB 6,LGS:L1-N,PE - Marker for terminal blocks 1051414

ZB 6,LGS:U-N - Marker for terminal blocks 1051430

UC-TM 6 - Marker for terminal blocks 0818085

UC-TM 6 CUS - Marker for terminal blocks 0824589

UCT-TM 6 - Marker for terminal blocks 0828736

UCT-TM 6 CUS - Marker for terminal blocks 0829602

ZBF 6:UNBEDRUCKT - Zack Marker strip, flat 0808710

ZBF 6 CUS - Zack Marker strip, flat 0825027

UC-TMF 6 - Marker for terminal blocks 0818140

UC-TMF 6 CUS - Marker for terminal blocks 0824646

UCT-TMF 6 - Marker for terminal blocks 0828746

UCT-TMF 6 CUS - Marker for terminal blocks 0829665

CLIPFIX 35 - End bracket 3022218

CLIPFIX 35-5 - End bracket 3022276

E/NS 35 N - End bracket 0800886

E/UK - End bracket 1201442

E/UK 1 - End bracket 1201413

SF-SL 0,6X3,5-100 S-VDE - Screwdriver 1212587

Your advantages

VIOK 1,5-D/TG/D/PE - Installation protective conductor terminal block

3011067